HUAWEI B525 2017 -4G 300Mbps, CAT 6, mobile WiFi Router, NOT UK warranty stock

Product Information

Halutessasi voit lukita yhteyden käyttämääntiettyä 4G-verkon taajuutta. Valitse Vain 4G (800 Mhz), Vain 4G (1800 Mhz) tai Vain 4G (2600 Mhz).

It seems happy enough to sit on Band 3 most of the time, but sometimes switches to Band 20, which is much slower, so I've disabled that band in the settings.In my B525 firmware there is a voip setting which I use with a Sipgate basic account, using a phone plugged into the B525 I do not get the drop to 3g but also cannot use the Three free minutes but the SMS still works. Did somebody try some kind of dd-wrt/tomato/gargoyle on this? Did you updated version has a BRIDGE mode? So after all that, everything works without me having to do anything other than be a bit more patient! Speeds are still pretty poor so even when you get the best that o2 can give, still ain't good enough. Although, better than Three, EE and Vodafone as non of them work in the buildings. If you can get an EE signal you can get 35mhz of capacity on Band 3 in many areas, as they have 20mhz followed by a second band 3 signal of 15mhz, which can be aggregated together. Plus band 20 (5mhz).

I suspect i'll always connect to that cell as it less than 100metres away with direct line-of-sight. I use mine in two different areas, one there is no coverage 3G or 4G going by the coverage map (right in the middle of a not spot) but get up 60mbps 4G+ (CA) down with 3 or smarty when using LTE inspecteur, sometimes the unit does select the best bands but mostly I have to force it. LTEBand is the value for the primary LTE bands available to the router this is not anything to do with aggregation, when not in use its set to 7FFFFFFFFFFFFFFFUnfortunately this firmware does not support band selection only 2G/3G/4G or auto. Bands can be modified though using bc LTEinspectuer and is maintained upon turning device off or rebooting. Kirjoita nettiselaimen osoiteriville osoite 192.168.8.1 ja kirjaudu sisään. Käyttäjätunnus ja salasana ovat molemmat oletuksena admin, muutoin käyttöönotossa määrittelemäsi salasana. Jos vierailet ensikertaa verkkohallintasivulla, tulee sinun käydä läpi pika-asetukset. Pika-asetuksista vain verkkohallintasivun salasanan vaihto on pakollinen. Voit vaihtaa kielen sivun yläosassa olevasta alasvetovalikosta. He did mention 90cm between the two routers on the window ledge. That could well cause a difference. The Cell ID on the router is 2946818 and the router itself is the 23a. I got the number 11511 after the putting the CellID number into cellmapper, in a vague attempt to try to work out which mast I was connecting to. Is there anyway to fix the router to B3....or doesn't it quite work as simple as that? To be honest I'm out of my depth with this at this level, so advice at rookie level is appreciated.