Compression 40mm Waste Pipe 90 Degree Bend

Product Information

Compression fittings consist of three parts: a nut, a ring and a seat. When the compression fitting gets tightened, it provides a watertight connection. Helping you find the right compression fitting Whilst cutting, keep your eye on your line and ensure the saw stays straight and true. Keep going until you are all the way through.

Tighten until the screw cap goes tight and then give it one final pinch and all should be fine. If you do find it leaks, simply screw up a little tighter. To do this, use a fine piece of sandpaper, at least 280 grit or greater or a small file and gently run it around the edges until smooth – Don’t press too hard as you will scratch the pipe and this may cause leaks. Once done, the pipe is ready to fit. Similar to our imperial fittings range, our selection of metric fittings includes elbows, olives, straight couplers, and tees to be used on LPG. Screw Cap: The final piece of the puzzle, this holds everything in place and ensures that the rubber seal provides a complete seal between the pipe and the main body Whether you need DZR fittings for commercial or residential construction, our collection includes adaptors, couplers, elbows, connectors, tees and stop ends designed for use in applications that deliver water consumption.Now comes the rubber seal. Again, make sure that the taper is pointing in the right direction so that it slots into the main body of the compression joint. Ensure that it is not twisted and that it sits flat on the body of the pipe Plastic Washer: Once the below screw cap is screwed up it applies pressure to the washer which in turn presses down on the rubber seal, holding it in place and ensuring it seals Assembly of the unit is pretty straight forward. If you have several sections of pipe to put together it’s best to get it together on a bench or open space if you can, then insert it into it’s final resting place in one piece and slot together the final sections. Assembly is as follows:

Compression waste adjustable bend taking two pipes of the same size (32 or 40mm) round from a straight line up to 90 degrees. Again, invaluable in a conversion or renovation situation Continue pumping the handles until the jaws close and cut all the way through the pipe and you’re done! Compression waste conversion bend. This bend allows you to change direction and convert from 40mm pipework to 32mm pipework and vice-versa Before you can actually fit a compression fitting you will most probably need to cut a section of pipe to the correct length for your needs. There are really only a couple of ways that this can be done, considering the size of the pipes (e.g. 32mm an upwards): Our lead fittings collection includes brass compression coupling for joining lead pipes to copper tubes. The fittings in this range are not suitable for gas use.Due to the size of pipe you are cutting (32 or 40mm), you will need to get some of the shear-type cutters. A compression straight coupling, joining two pipes of the same size in a straight line. 32mm and 40mm Screw down the cap. Take your time while doing this and keep your eye on the seal and washer making sure they do not twist and that all is flush with the main body and pipe. Screw up until it starts to go tight and then give it one final pinch to create your water tight seal Open up the shears to their full width and place the pipe on the base of the jaws. It does help to rest the cutters on bench or stable surface to support them and the pipe.

Our Irish compression fittings are made of brass bodies and olives. These are for use with Irish copper pipes.As above, measure and mark the position on the pipe that you want to cut, mark your point with a soft pen.