TP-Link JetStream 24-Port Gigabit L2 Managed Switch with 4 SFP Slots, Supports 24 Gigabit RJ45 ports, Rackmount (TL-SG3428)

Product Information

If you only have USB ports on your computer, you can get a USB-to-RS232 cable. You may need to install the RS232 driver for the cable, which is provided by your cable vendor.

With Fast Leave enabled on a VLAN, the switch will remove the (Multicast Group, Port, VLAN) entry from the multicast forwarding table before forwarding the leave message to the querier. This helps to reduce bandwidth waste since the switch no longer sends the corresponding multicast streams to the VLAN of the port as soon as the port receives a leave message from the VLAN. The vlan command is used to create IEEE 802.1Q VLAN and enter VLAN Configuration Mode. To delete a VLAN, use no vlan command. How to configure IGMP Snooping for IPTV network on L2 Managed switches using the new GUI 06-27-2022 139402 Using the Omada controller to configure multiple SSIDs with different VLANs on TP-Link Omada EAPs and Switches to work with a non-Omada gateway(Multi-Net NAT supported) 06-08-2023 17569 You can use the Auto-Completion feature to enter a complete command, you can also enter part of the command without completion, and the switch will recognize and execute the command automatically.Some official firmware of TP-Link products can be replaced by the third party firmware such as DD-WRT. TP-Link is not obligated to provide any maintenance or support for it, and does not guarantee the performance and stability of third party firmware. Damage to the product as a result of using third party firmware will void the product's warranty. Open Source Code For Programmers (GPL) Normally, all switch ports are member ports of VLAN 1. If you do not want to remove a port from VLAN 1, you need to additionally configure it. Please note: The products of TP-Link partly contain software code developed by third parties, including software code subject to the GNU General Public Licence (“GPL“), Version 1/Version 2/Version 3 or GNU Lesser General Public License ("LGPL"). You may use the respective software condition to following the GPL licence terms. Using the Omada SDN Controller to Manage Omada Devices Across Multiple Locations Via a Controller (5.0 and Above) 05-31-2023 20224

In summary, to set a port as an access port for a certain VLAN, take VLAN 100 as an example, the common configuration is: If your computer has a serial port (COM), please connect it to the console port (RJ45) of the switch, with the RJ45 console cable.

To Use Third Party Firmware In TP-Link Products

V2: 1589.31 BTU/hr (110 V/60 Hz) (with 384 W PD connected); 117.38 BTU/hr (110 V/60 Hz) (no PD connected)