Remington Airetrex 365 Home Air Sanitizer (REM-7365UV-120)

Product Information

SOLUTION: You can attempt to replace the spring and restring the recoil. If it does not work because other components in your recoil are damaged, such as the clips or the pulley, you are better off just replacing the recoil assembly. 12. Plugged Spark Arrestor SOLUTION: Make sure the on/off switch is placed in the on position. A faulty switch or bad ground wire can also be the reason a chainsaw won’t start. 2. Old or Bad Fuel

Remove a plugged air filter and clean it. Replace the filter with a new one if it is very dirty, wet, or damaged.It can also happen with the switch off and the starter rope being pulled multiple times or when the primer bulb is pushed too many times. Wipe around the fuel cap to keep any dirt from falling into the fuel tank when removing the fuel cap. One thing you don’t want to get wrong is the type of fuel you add to your Remington chainsaw. Getting this wrong can cause permanent engine damage. Still Having Problems with Your Troy-Bilt Chainsaw? Common Remington Chainsaw Starting Problems 1. Bad Switch or Wrong Choke Setting

It may also not start when the on/off switch is bad or the engine is flooded. Before performing repairs, always remove the spark plug boot. Follow all safety precautions in your Remington operator’s manual. SOLUTION: Inspect the spark plug and clean it with a wire brush if it is in good condition and just a little dirty. Replace a spark plug if you find it is very dark in color, has a burnt electrode, or has broken porcelain. Hold the fuel line securely while pulling the filter out of the fuel line. Don’t let go of the fuel line. The negative ions emitted by ionic hair dryers help to reduce frizz and flyaways by counteracting any positive charges generated by the drying process. This seals the cuticle faster and reduces the size of water droplets, therefore requiring less heat, less energy and less time to dry hair. The result is shinier and, with long-term use, healthier hair. When this happens, the spark plug won’t get the voltage required to create a spark. This will cause your chainsaw problems.SOLUTION: If you find you have placed the wrong fuel mix in the fuel tank, drain the tank and add the right gas-to-oil mixture. Attempt to start the chainsaw. Replace a bad spark plug. Make sure the electrode gap is correct and the spark plug wire is securely in place. SOLUTION: Remove the air filter and clean it if it’s a little dirty. If the filter is extremely dirty or damaged, it must be replaced. Never run a chainsaw without an air filter.

Sawdust and dirt go flying through the air when operating a chainsaw. To keep this dust from getting into the cylinder and wearing on the engine, an air filter is installed to ensure the engine receives clean air. Replace a damaged or missing spring. Restring the recoil starter if needed. Replace the recoil starter when it is damaged. Add a fuel additive like Sea Foam Motor Treatment or STA-BIL to help reduce moisture and clean the fuel system.Reinstall the filter and make sure it securely seals the opening to the air intake so dirt will not bypass the filter. A fuel restriction can be created when the fuel line becomes clogged. This can prevent the chainsaw from starting. Take note of how the filter is positioned in the fuel tank to ensure you place the replacement filter correctly. SOLUTION: When you are having starting problems and you find the fuel is old, empty the tank and fill it with fresh fuel. When the filter isn’t changed regularly or when dirty fuel has been used, it can become plugged not allowing sufficient fuel to pass through the filter. This may cause the saw to fail to start or run sluggishly.