Amtech F1210 50mm (2") Core drill

Product Information

However, leaving it in will allow you to see when it is about to break through the opposing side of the wall you’re drilling through. More about this and why this is a good thing can be found below.

As well as wearing the drill bit out much faster, the hammer action also creates a lot of vibration whilst drilling often leading to the hole ending up larger than intended. Due to the amount of heat created during the drilling process it is necessary to keep diamond core bits as cool as possible to prevent unnecessary damage to the cutting teeth to a minimum. If the surface of the cutting teeth are subjected to too much heat the metal encasing them melts covering the diamonds and reducing cutting efficiency. If this happens the drill bit then needs to be “redressed” to expose the diamonds once more. Essentially the speed that you drill at will be dictated to you by the size of hole you are drilling. As a very general rule of thumb, the larger the hole you are drilling and the denser the material you are drilling through, the slower the speed you should drill at. When hiring or buying a core bit always make sure you have the correct size and type of arbor for not only the core bit your are using but also for the type of drill you have e.g. SDS, spline, straight shank etc. In general, the bigger the hole, the more expensive it’ll be. However, you can also expect to pay less per hole if you’re getting a lot of holes done as opposed to just a few.Before you start any drilling, the first job is to measure and mark the exact spot that you want to drill your hole so there isn’t any mistakes. For example, smaller holes up to 30mm in diameter can be drilled at up to around 3000 rpm whereas large holes around 400mm should be drilled at speeds as low as 300rpm. There are many core drill sizes and generally each size is manufactured to represent the size of a commonly used pipe, cable or duct so that once the hole is drilled, the object in question passes through with ease.

Trying to drill more dense objects such as solid concrete will in most cases cause the bit to heat up, wearing it out even faster. If you don’t already have a suitable drill, any decent hire company will gladly supply not only the correct drill but also the correct diamond core bit, if purchasing either the drill or core bit is deemed too expensive. Remember you will also be charged for the amount of wear on diamond tipped bits. Keep drilling until the core drill teeth hit the surface of the wall. You will feel them bite once they do. The main difference between core drilling and other methods of cutting concrete is that a core drill will actually remove a cylinder of material from the structure – the part that was enclosed by the hollow centre of the drill. This is called a ‘core sample.’ Key takeaways

Sign up for special offer emails

When drilling your hole, always hold the drill and core bit dead level. You do not want to drill in at an angle and cause the hole to slope up or down! CLEAN AND PRECISE CUTS - Enjoy clean and accurate drilling with our segmented design, providing outstanding cutting performance and minimizing the need for an additional filling. Perfect for various tasks like drilling vent pipes, drainage systems, and more. In general, a corded drill is the best to go for as it will produce power at a more constant rate, but if funds are available, the more expensive and higher quality cordless drills (minimum 24v) from brands such as DeWalt, Makita, Milwaukee etc should provide more than enough grunt. As always at DIY Doctor we advise the use of purpose built tools for DIY use. Safety must always come first. Wear the appropriate safety equipment, gloves, dust masks and eye protection at all times.