V23074-A1001-A402 12V 4PIN PA66-GF25

Product Information

It was found that the route in which the boiling water bath is applied after the “supporting mold” is preferred to ensure the dimensional accuracies and the mechanical properties as a whole. AKRO®, AKROMID®, AKROLEN®, AKROLOY®, AKROTEK®, ICX® and PRECITE® are registered trademarks of the Feddersen Group. The values of the tensile and bending strengths, elastic modulus, and elongation at break are measured on a CMT5105 universal testing machine (Mattes Industrial Systems Co. While we have placed significant efforts in ensuring data accuracy, "typical" and "predicted" data should be considered indicative and verified by appropriate material testing. However, to improve the chemical, corrosion, mechanical, and heat resistance [ 1, 2, 3, 4], reinforcing phase, such as glass fibers (GFs), is added to the PA66 matrix to manufacture glass fiber-reinforced composites (e.

This can result in dimensional changes up to 2% and a corresponding reduction of physical properties. The hygrothermal behaviour of glass-fibre-reinforced thermoplastic composites: a prediction of the composite lifetime.The dimensions of the plate were measured as described in Section 3 and combined with the shrinkage formula for the injection products (Equation 1) to study accuracies in the periphery dimensions and the central hole diameter of the plate treated by the three routes. To further study the effect of the three treatment routes on the crystallization behavior of the dried plate to ensure the employment character, an XRD analysis was carried out subsequently.

The temperature of the injection molding machine from the hopper to the nozzle is divided into three segments; more precisely, the ranges of temperatures of the first, second, and third segment are 275–285, 260–275, and 250–265°C, respectively, while the injection pressure is 85 MPa, the dwell time is 3 s, and the injection speed is 50 mm/s. This result shows that the “supporting mold” can reduce the difference in the shrinkage of the central hole in the two directions, thus increasing the dimensional accuracy. However, after re-drying, the parts shrink again, which indicates that re-drying prevents the plate from swelling during boiling in the water bath [ 18].Structure–property relationships in glass reinforced polyamide, part 2: The effects of average fibers diameter and diameter distribution.