Osciloscopio fnirsi 1014d - generador de señal DDS de osciloscopio digital en dos en uno, ancho de banda de 100 MHz de 2 canales 1gsa / s tasa de muestreo

Product Information

The signal has been greatly attenuated when it reaches the input end of the oscilloscope through the probe, and the equivalent bandwidth is 5MHz. Ideal for a beginner or someone just trying the basics, or wondering if an electronics hobby is for them. I tried slope triggering, it helped only a tiny bit, there’s no way to keep the trace steady on the screen. As part of what is on EEVBLOG, resources for the reverse engineering of the FNIRSI-1013D scope are put together in a single repository.

FNIRSI 1014D - How to upgrade the firmware - TechCorner.TV FNIRSI 1014D - How to upgrade the firmware - TechCorner.TV

Please check whether the probe is normal with multimeter 8: Why does the test waveform shake around and cannot be fixed? Moreover, the data of duty cycle will be correct only after at least one clear periodic waveform is displayed on the screen 6: Why is AC coupling the same as DC coupling waveform? The scope triggers and locks to 200 MHz with reduced amplitude accuracy, but useful qualitative display. It’s a lot of money to waste on an unreliable, frustrating tool which often emits meaningless measurements and gives you little clue about it. High Measurement Voltage Range: 1X mode can measure 0 40V, and 10X mode can measure 0400V, giving you the flexibility to handle a broad range of signals.I’m not wild about touch screen… knobs are nice and simple and intuitive to use, the more the better I suspect. Built-in DDS Signal Generator: Supports 12 different kinds of function signals, offering comprehensive signal generation for a wide variety of applications. But even worse then all of this is probably that this manurefacturer blatantly lies about it spec’s. You would also eliminate the scope probe by connecting the high speed pulse to the BNC (or other high speed connector) and using 50 ohms termination.

FNIRSI 1013D teardown and mini review – A portable FNIRSI 1013D teardown and mini review – A portable

I have one of those kit KT15001 (and a multitude of other names) suckers, with just one channel and a suspect quality probe. Lissajous figures graphic display function can be used to determine the amplitude, frequency, and phase contrast of two groups of signals. The unit can also be run from its USB-C port, but I wouldn’t want to count on cat III/IV safety rating when powering by USB.

I would never have imagined of a such disappointing purchase, I have an oscilloscope that is totally useless for measurements of low amplitude signals.