About this deal
In this short guidewe’ll look at how to clean Hitachi nailers using the 705470 cleaning kit. We’ve detailed each step of the process below and you can watch a Hitachi NR90GC nail gun being cleaned in our Toolstop TV video. Over time, a nail gun’s bolts and screws can come loose due to vibrations and heavy use. Loose parts can jeopardize the tool’s integrity. So your Paslode’s now clean – hopefully it seems refreshed. But is it firing like it should? As well as regular cleaning, your nail gun also needs new spare parts fitted every now and then. The o-rings, battery pads, filter, etc. get worn out and need replaced. If you don’t want to splash out on the pricey Paslode nail gun cleaner, try these Paslode degreaser cleaner alternatives. 1: Brake cleaner
Paslode | Screwfix Paslode | Screwfix
Each nail gun brand will have its own recommendations for cleaning, which will be included in the user manual. If available, it’s advisable to hit the nail gun with a bit of air to mop all the spots you can’t wipe. Do not put off tightening screws and bolts. A missing screw or bolt can make it difficult to maintain control of the gun, which can be dangerous. Battery Inspection (Cordless)
How to Clean a Paslode Nail Gun
Your last step is re-oiling -use the right Paslode gun oil (or a good paslode oil alternative as well) for lubing- be sure to place a couple of drops around the tool’s cylinder wall. Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie.
Paslode | Toolfix Hardware | Ireland Paslode | Toolfix Hardware | Ireland
Most experts recommend adding a few drops of air tool oil to nail guns before using them. Oil should be added to the gun’s moving parts and the fitting at the bottom of the tool.A pneumatic nail gun’s seals need to be changed from time to time. A bad seal can cause the tool to lose power and may damage the nail gun if left in disrepair. Something else: You’re advantaged when you use the recommended paslode cleaner and oil – it’s specially engineered for the tools and cleans wonderfully. Step 6: turn your attention to the impeller blade on the motor. If this needs cleaned, again use the aerosol, brush and cloth.