Airflow iCON 30 Extractor Fan 230V 100mm Outlet, White, 27 W

Product Information

Please note: While the Icon 30 uses 4" inch ducting it does require a 6" hole in the wall or ceiling for flush fitting. If you don’t already have a fan, you’ll need to get in a qualified builder to make the hole and install the wiring. Be aware that there are regulations governing where your fan can be located: if you want to put a fan in Zone 1 (the area within a shower or 2.25m above a bath) or Zone 2 (60cm from Zone 1), it must be a low-voltage SELV fan with a transformer, or an AC-powered model that’s IPX5-certified. Most of our recommendations below are intended for use outside of Zone 2, but the layout of your bathroom may dictate your options.

The more powerful and slightly larger Icon 30 Bathroom & Utility room unit can be installed similarly to the Icon 15 either as a surface mounted 100mm/4” fan or flush mounted as a 150mm/6” install by removing the rear cowl.Finally, if you think you (or anyone else in the house) will forget to turn the fan on, consider a model with a humidity sensor. This automatically activates the fan when the level of moisture in the air exceeds a certain threshold. This sensor may need occasional cleaning, though, or the accumulation of dust or grime will hinder its effectiveness. What about noise? This standard 30 model (72591601) is suitable for installation into zone 3 of the bathroom and offers basic on/off switching. Choose an optional control module to expand the functionality and automation:Pullcord, Timer, Humidity or Motion Sensing options. Model above is for basic on/off switching. Choose an optional control module to upgrade fan for Pullcord, Timer, Humidity or Motion Sensing operation. Don’t forget to add the control module you want. Any module fits any fan. Its so iCON easy! Applications The precise duration of the overrun is normally configured during installation, with most fans offering a range between 30 seconds and 30 minutes. You might as well tend towards the latter end of the scale as the cost is very low: on average, a fan like this uses around 8W. The Airflow ICON30 72591601 ventilation fan is suitable for fitting into walls or ceilings in areas such as shower rooms, bathrooms, en-suites and toilets.

Each fan in the range has a slot to insert a control module of your choosing, including options for pull cord, over-run timer, Humidistat and Passive Infra-red PIR sensor.

Specification

Tiling is a breeze with the circular cover flange, reducing the need to 'make good' and one wipe and the cover is clean. The Airflow Icon range is a great looking axial extractor fan which thanks to its eye-catching 'opening iris' shutter, has become a modern design classic. PRHTM - Infrared - Passive infrared activation with adjustable humidity setting and adjustable timer overrun