MYSON Radiator Bleed Valve/Screw/Vent/Nipple Replacement

Product Information

You will want to take your new plugs and wrap the PTFE tape around the threads, pressing the tape into the grooves as you go. How many times you wrap the thread will depend on the valve, but 3 times around is a good benchmark. They’re typically placed at the top of the radiator because any air that will be trapped inside will be forced upwards by the pressurised water below.

We can provide dedicated support for the commercial and specification market in areas such as hotels, schools, hospitals and a variety of other commercial installations Keep the valve open until the water stops flowing out although if you are unable to open the bleed valve, move on to step 4. Step 4 – Remove the Bleed Plug Myson Column radiators can be curved to fit most applications, upon special request. Or alternatively smaller radiators can also be used to make up the total length of the Our TRV valves are perfect for any project, whether it’s new-build, self-build, social housing or large commercial projects, MYSON have the optimum productto complement our heat emitter range

Our unique range of TRVs includes TRV2, including a Petite version, remote sensor heads, TRV bodies, an attractive decorative model, as well a specially designed TRV kits to complement our LST radiator range. Now you will need your adjustable spanner to remove the bleed plug (and the blank on the other end).

One of the most common reasons for replacing a bleed valve is that the bleed valve has failed and is leaking.

Registration for our free email newsletter.

The MYSON TRV2 range includes over 20 different products with compression or push fit connections in 10mm, 15mm and ½” sizes

As you can see, this is not a difficult task and no need for panic stations. The best thing to do is keep calm and carry on. The article above is aimed at replacing standard bleed valves located on most radiators. Note: If you were unable to open the bleed valve in step 3 – undo the plug slowly and be prepared for some water to escape. Step 5 – Wrap Your New Plugs with PTFE Tape I managed to shear off the middle bit of my radiator bleed valve yesterday, just by turning it with a key. After removing the plugs there will be a bit of air in the system that should make it to the AAV although now would be a good time to make sure all of the radiators are bled. ConclusionCentral regulator for underfloor heating components including; thermostats, actuators, pumps and boiler Our PETITE range has over 10 different products with compression or push fit connections in 10mm, 15mm and ½” sizes