Gardner Bender DS-130 Duct Seal Compound, 1 lb. Pug, No Size, Grey

Product Information

We'll start with some information about polyurethane DIY foam comparing to our MD5 Duct sealing Resin. After injecting, the polyurethane sealant will expand and cures/hardens with a high density and a closed cell structure

An effective and simple solution for penetrating fire rated walls and floors. The system can be used for cables, metallic pipes, plastic pipes or even a mixture of all 3 service types. It is vital, to make sure the duplex foam is wrapped around each cable, to create separation from each other and the inside of the duct. Running water Are you not convinced yet to use our MD5 Duct Sealing system instead of DIY Expanding PU foam from a can? If not, please read the test data below, performed by ourselves. You won't find a single manufacturer of expanding foams in a can with the same test data for sealing cables in a duct. Duct sealing system type MDII has been developed to provide an effective and simple solution for all your Gas and Watertight duct sealing requirements. Seals internally & externally around the outside edge of the ductShould any un-mixed material spill onto a surface, a solvent wipe can be used to help clean the area. Reentering & removal

CSD's team are very focused in their approach to provide a high quality product and service. We are looking forward to working with them in the future” Power Cables – specified to seal high voltage and heavy armoured power cables in single, trefoil or Triplex arrangementIf there is room and the cables are de-energized, a power tool to speed the process up could be used. Once the seal is broken from the cable, there may be a crust of resin still present on the cable; this is due to the excellent adhesion our resin has. The hardest part of removing this seal is the crust that forms when the resin soaks into the foam flange. Safety Designed for empty or single service penetrations. Combines fast and simple installation with effective sealing performance against gas and water ingress. Thesystem can be used for cables or metallic and plasticpipes. The service provided by CSD was excellent in all aspects. The installation crew were skilled, hard-working and resourceful and also integrated well with our own men who supported then with the external duct sealing.” Selection should be at the design stage, where the seal requirements can be matched to the overall project. Typically, a design specification will require water, gas and perhaps fire resistance together with specific chemical resistance. The life of the seal needed should also be considered. Every seal manufacturer should be able to provide proof of expected life. Over-engineering the seal design should also be avoided. A duct sealing solution that meets the specific needs of the application is the right solution. Failure to correctly and effectively seal cable ducts can inflict catastrophic damage to LV-HV electrical distribution networks, substations and power supply. View below our complete ranges of Duct Sealing Products including cable transits to provide a watertight seal and defence against flood damage to low, medium and high voltage cable ducts with additional protection against harmful flammable gas migration and fire spread.