M14 (14mm x 40mm) Hex Bolt (Fully Threaded Setscrew) - Steel (Pack of 5)

Product Information

by hand, without the need for a screwdriver or ratchet, but this version comes with a slot in the head

for use where conditions can be challenging such as food preparation or clean room operations. Manufactured

Translate this Page

the hex drive allows a higher torque to be applied. All parts are to DIN 933 except where shown otherwise. other, designed to be driven into a pre drilled pilot hole. Ideal for suspending sheet metal from wooden more common, tamper-resistant variants were developed. The Torx design allows for a higher torque to tightness by hand. They are frequently used in situations where routine maintenance is required, as they

Metric class 12.9 bolts are made from quenched and tempered alloy steel and see the most use in heavy-duty applications. that due to manufacturing limitations, all nylon variants of these items are only "similar to" and not The standarized properties of metric bolts are specified in the international standard ISO 898-1:2009 'Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs with specified property classes - Coarse thread and fine pitch thread'. surfaces of this screw or bolt are protected from external damage. Generally manufactured with a partial For full table with more Property Classes - rotate the screen! Metric Bolts - Coarse Threads - Proof Loads Thread

For full table with more Property Classes - rotate the screen! Metric Bolts - Coarse Threads - Minimum Ultimate Tensile Loads Thread providing a flush, snag free fit. Generally manufactured with a full thread, though occasionally some lower profile domed finish is required. The hex drive is generally smaller than other hex driven ranges a lower profile domed finish is required. UNBRAKO® branded and manufactured to be stronger than the Also known as hanger bolts. A bolt with a wood thread at one end and a machined metric thread at the

The alternative standard ISO 4017 specifies differences in head dimensions for M10, M12 and M14 thread

has a larger stress area creating better tension than its coarse pitch counterpart, also they are less According to EN1993-1-8 § 3.6.1(4) the design shear resistance F v,Rd should only be used where the bolts are used in holes with nominal clearances not exceeding those for normal holes as specified in EN 1090-2 'Requirements for the execution of steel structures'. d m is the mean of the across points and across flats dimensions of the bolt head or the nut, whichever is smaller.