About this deal
We intend that these Terms and Conditions apply only to a Contract entered into by you as a Consumer. If this is not the case, you must tell us, so that we can provide you with a different contract with terms which are more appropriate for you and which might, in some respects, be better for you, eg by giving you rights as a business.
The positive + side of each led is identified by a longer lead and the negative – side by the shorter lead. the party's obligations will be extended so far as is reasonable, provided that that party will act reasonably, and the party will not be liable for any failure which it could not reasonably avoid, but this will not affect the Customer's above rights relating to delivery.To limit the current to 10mA, a 220 ohm resistor is placed in series with the leds and the supply voltage is set to 30 volts. be reasonably fit for any particular purpose for which you buy the Goods which, before the Contract is made, you made known to us, expressly or by implication, regardless of whether that is a purpose for which goods of that type are usually supplied (unless you do not actually rely, or it is unreasonable for you to rely, on our skill and judgment) and be fit for any purpose held out by us or set out in the Contract; and Consumer means an individual acting for purposes which are wholly or mainly outside his or her trade, business, craft, or profession. In the case of any Goods made to your special requirements, it is your responsibility to ensure that any information or specification you provide is accurate.
Drill two holes through the cork. The drill diameter (1mm) should be slightly smaller than the diameter of the stiff wires on the led heart. Smithers of Stamford Ltd, 6-8 Broad Street, Stamford, Lincs PE9 1PG United Kingdom. Tel 01780 435060 If the base of the bulb comes apart from the glass during the grinding process then it can be reattached using epoxy adhesive. Delivery service for all parts of the UK including London, Manchester, Liverpool, Harrogate, Cambridge, Oxford, Leeds, Brighton, Bournemouth, Birmingham, Bath, Devon, and Cornwall.
Make the lamp base
Glass is incredibly sharp and can fly some distance when it breaks, therefore careful handling of the bulb is necessary. Using a rotary sanding attachment in a rotary tool, enlarge the top half of the hole until the copper tubing fits snugly.