BRITISH GAS WIRELESS RECEIVER WR1

Product Information

I'm having problems getting a Worcester Junior 28i combi boiler lit for central heating now the temperature is dropping (it works fine for hot water).

Adjusted programmer & thermostat so that there was no heat demend, changed programmer time to come on in 5 minutes, turned Digistat up to 23C and waited. NatWest, Royal Bank of Scotland (RBS) and Ulster Bank, which are all part of the NatWest Group, will now shut at least 172 of their bank branches in 2023 and 2024. stand a meter away from reciever then insert right battery drawer then left light should flash on reciever then go out.My system is labelled "British Gas WR1 Wireless System" which is the sensor by the boiler and the thermostat is labelled "British Gas RC1 Wireless System" Push button 1 followed by 2 and hold them both depressed together Red LED will flash for 2 secs then go out (learn mode)

What is happening now is that if I press button 2, sometimes the green light will light but will switch off again as soon as I release the button. These wireless stats are/were often fitted by BG. They are probably rebadged Drayton Digistats. Alas they have an unfortunate failure mode that can cause the stat and the receiver module to become "unpaired". My search proved in vain as l could not come up with any posts to do with RC1 or WR1. I went to bed with an extra duvet at that point. Make sure both battery compartments are out on the 'Wireless Display' and the screen has gone blank, takes about 2 mins to fadeIn addition, when attempting to re-pair the receiver and transmitter, the receiver red LED is supposed to flash for 7 seconds after the batteries are put into the transmitter - it doesn't. I've gone through the procedure several times to no avail. Turned mains supply off (& verified), removed WR1 (SCR) unit from the wall managed to prise the clips holding it together apart (without breaking any) de-soldered the old cap and re-soldered the new. The batteries died on my wireless thermostat and there were no instructions or manuals from the previous owner of the property. Q is: has anybody else had my original problem - led display on remote blank - and found a way to sort it? and

press button 1 (lower) then 2 and hold both depressed you should see a red light flash the reciever is then in learn mode.

British Gas wireless thermostat

find the reciever box prob in airing cuboard it has learn and overide written on it, turn the room stat up and down and see if the recieve light flashes if it doesnt the room stat is not communicating with the reciever. Press the overide button and the green light should come on and fire the boiler if boiler doesnt fire you could have a fault with the heating, if it does fire then the room stat needs recommisioning. I have seen other posts regarding issues with these units but they don't seem to be quite the same as my problem. Do you have a Power of Attorney? MoneySavingExpert.com founder Martin Lewis explains how this crucial protection works, why it's more important than a will, and how to get one in the latest episode of ITV's The Martin Lewis Money Show Live. If the red LED reamins on you need to repeat all of the above If it is still on something is wired incorrectly or broken