Autoglym Polar Seal, 1L - Thick Snow Foam Pressure Wash Coating For High-Gloss Finish On Your Car Exterior

Product Information

I had high expectations from it for ease of use and great results, which seems to be the usual Autoglym way. Spray Polar Blast onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels. It is important that Polar Seal does not dry on to the surface of the vehicle. Once the car has been coated it should be rinsed immediately. Can Polar Seal be used on my alloys and exterior plastics?

Although it might seem like the perfect opportunity to wash your car when the sun is shining, make sure it isn’t too hot to touch. If the bodywork is hot, the shampoo can dry out on the car. We would recommend that only the product needed for a single application is used. We also recommend that the foamer bottle is rinsed thoroughly after use.

Bilt Hamber TOUCH-ON Crystaline Hydrophobic Shampoo & Sealant

We recommend a pre-wash with Polar Blast to gently loosen dirt. If not, rinse first with water to loosen heavy contamination. Polar Seal contains silicones, which in some cases, can create smears once wiper blades are used on the windscreen. We would recommend cleaning your windscreen after you have applied Polar Seal to the rest of your car as part of your car cleaning process. How long should I leave Polar Seal on my paintwork? Windows are not much use if you can’t see out of them! Get your car windows gleaming with Autoglym’s Car Glass Polish; use inside and out for crystal clear, smear-free vision.

It is a coating designed specifically for use in a pressure washer. It is the coating element (third and final stage) of the three-stage Polar range process. It is preceded by the prewash – Polar Blast and shampoo – Polar Wash. Is Polar Seal wax safe? Leave Polar Blast time to dwell and loosen dirt for up to 10 minutes, although do not allow it to dry on. Polar Seal is a durable hydrophobic coating. However, it does not offer the same long-term protection as Ultra High Definition Wax or Extra Gloss Protection. So it sprays on easily and evenly via the foam lance and then on to rinsing. It rinses really easily and leaves amazing gloss.

Polishing your car is a great way to fade small scratches and imperfections. Find out how with our handy guide. Ensure your car is still damp before applying Polar Seal and allowing it to dwell on the bodywork for up to three minutes before singing off. You should see an immediate hydrophobic layer of protection, evident with some truly gorgeous water beading. It's an incredibly easy way to get some extra protection, the only downside being that you can't apply Polar Seal to a windscreen, which means some careful trigger action. Following Autoglym's instructions to the letter will also give you 25 washes from this bottle, not a bad value for the price of the bottle. It's worth noting that in this price range there are several excellent five-litre snow foams for sale that'll do roughly the same job. Bilt Hamber Auto Foam is a good example of this. That's not to say that Polar Blast is bad value for money, it's just worth remembering that you can get more for your money.

Polar Blast can be used at various dilutions depending on the density of foam desired. A good starting point is 100ml product to 500ml water in your foaming bottle. Adjust foam gun settings as required to increase or reduce foam. Also used the Instadry for the first time, that is a fantastic product also. I didn’t expect it to be as small as it was but it dried a large saloon with only a few wrings out in between. It seemed to glide across the paintwork and soak up water really well.

I did also buy some Polar Wash, but with the weather being so cold I decide against using it as the pressure washer will dump a lot more water on the ground than 2bm. So I followed with AG Pure Shampoo then a rinse. Wax on, wax off! Don’t let all your hard work go to waste. Adding a layer of wax or polish to your car will help to fend off any nasties that could land on the paint, whilst protecting your car from UV rays. Use the Autoglym Polar Seal to give your car a protective, hydrophobic coating that will leave it looking glossy in no time.

Ive used demon shine in the past and was very cheap and worked very well help dry the car and add some shine However i only used it via the original spray bottle so it hurt my hand haha after going over the whole car with it...but i didnt think of applying it via foam lance to be honest.. Only a small amount of Polar Seal is required. Pour no more than 40ml (four capfuls) into your foam bottle and then add at least 200ml of water. This should be all the finished solution required to cover your vehicle. There is no benefit in using any more than 40ml as over application can compromise the finish. Last but not least, remember to use some interior protection! Apply Autoglym’s Vinyl And Rubber Care solution to the interior by lightly buffing to a finish with a microfibre cloth. Keeping your car exterior clean is a great way to take care of the aesthetic of your car as well as its longevity. Follow our step by step guide. Being a massive Autoglym fan and the fact they released Polar Seal a week or so ago, I hankered after getting some of this and giving it ago.Thoroughly rinse and dry your car to reveal a high-gloss finish that is protected with a hydrophobic coating. The car must be dried with a cloth and not allowed to air dry as water spotting may occur. We would strongly recommend not using more than 40ml Polar Seal and 200ml water. Over use may cause white spotting and significantly compromise the effectiveness of Polar Seal. Using more product will not improve the depth of shine or increase its durability. The Autoglym Polar Kit contains 3 products used via a pressure washer to maintain & protect your vehicle. We recommend starting with a snow foam like Polar Blast to gently loosen dirt, and follow with Polar Wash to remove any dirt or contamination on your paintwork. a>