Joined in 2023 
82 
63 About this deal
For redundancy, these sensors are polled every 60 seconds together with the update of all other entities.
If you just received your new camera and are not familiar with the camera, you can have a look at the below video about the unboxing, setup, and installation of the camera. iSpyConnect has no affiliation, connection, or association with Reolink’s products. The connection details provided here are crowd sourced from the community and may be incomplete, inaccurate or out of date. We provide no guarantee or warranty that you will be able to connect to your cameras using these URLs. The Images stream provides a sequence of image snapshots giving very low latency at the cost of a very low frame rate; this can be used when the RTMP/RTSP/FLV video stream has too much lag.Guard set current position will set the current position as the new guard position. Select entities However, these cameras can work with this integration through an NVR in which the NVR is connected to Home Assistant. When IR light entity is OFF always OFF, when ON IR LEDs will be on when the camera is in night vision mode, see the Day night mode select entity. Sensor entities If you fail to add Reolink cameras to Synology, please follow the below steps to make troubleshoot. There are several possible causes for Micro SD Card Not being Detected on Reolink App. You may follow the troubleshooting tips listed below to solve the problem.
The latency for receiving the events is the best for ONVIF push and the worst for fast polling, the fastest available method that is detected to work will be used, and slower methods will not be used.To ensure you have the best latency possible, refer to the Reducing latency of motion events section. Asterisk (*) next to entities listed in this documentation To set up the camera, you need to connect the camera to a PoE switch/injector for network connection. After that, you may finish the initial setup via both Reolink App and the Client. My RLC 520a is running the latest firmware 3.0.0.494 and I have also tried the previous version 3.0.0.250. When using the siren turn-on service, the siren will continue to sound until the siren turn-off service is called.
Connect your PoE camera to the PoE NVR by a single network cable, then the PoEcamera will get power via the PoE NVR.If an entity listed below has an asterisk (*) next to its name, it means it is disabled by default. To use such an entity, you must enable the entity first. Number entities A brand new Reolink camera first needs to be connected to the network and initialized. During initialization, the credentials for the camera need to be set.
If you just receive your new camera and are not familiar with the camera, you can have a look at the below video about unboxing, setup and installation of the camera. Normally, the digits are printed directly under the QR code. Alternatively, you could scan the QR code and grab the last 4 digits. These models are discontinued and not sold anymore, they will continue to work with Home Assistant. However I discovered that the sound and audio were gradually drifting out of sync - up to about 4 seconds apart. The video is lagging behind the audio. This means that not only is the recording out of sync but also the snapshot starts to miss the event due to the video lagging. If I disable and re-enable the camera in SSS it is all great again but then the drift starts again.The camera may work in extremely cold conditions as low as -25°C as it will produce heat when powered on. You may power on the camera indoors for a few minutes before installing it outdoors. Floodlight turn on brightness controls the brightness of the floodlight when it is turned on internally by the camera (see Floodlight mode select entity) or when using the Floodlight light entity. Please note that the optimum distance between the camera and the PoE switch/Reolink NVR is 300 feet.
Great Deal 
New Comment