Aladdin EasyFit Isolator Valve and Tools Pack - Starter Kit

Product Information

The EasyFit Isolator saves time cooling, draining down, refilling and returning to de-aerate. The bigger the system, the bigger the saving. No more freezing kits and the risk that an ice plug will fail. It may take a few turns to turn the water on. It may also take a few minutes for the water to start running from your taps, as it will need to run through the pipes again.

This is the 1/8” BSP model. We provide a 1/8” Micro model that will fit cast Iron ‘School Type’ radiators (made in cast iron or aluminium section). Even when you can’t freeze you can still EasyFit to pipes with moving water, without the need to turn off the main external / internal service valve.

Yes, provided the temperature of the piping allows the valve to operate at 35°C for the Hygroseal™ Autovents. 14) Can the valves work on negative pressure systems? Install a permanent isolation valve called an Aladdin valve. This can be installed on hot water or cold water pipes in around 5 minutes and can be done without turning off your water. The Micro Barlo fits ‘Roll-Top’ radiators. These have a rolled over steel smooth top to the radiator panel. The left and right edges are welded seams. One model has the bleed pin facing to the wall and on a double panel a second bleed pin also faces outwards. Yes, the EasyFit Isolator is designed to be fitted to live pipes hot up to 85°C or cold pipes. 2. When the EasyFit Isolator cuts into the pipe what happens to the piece of pipe which is removed? If isolating a mains water feed in a multi-occupancy building, save time notifying and inconveniencing neighbours

On a Closed, pressurised system: After the air absorbed in the water has separated, the best early indicator of a leak is a drop in pressure of the system. An Autovent should, if anything, lead to a faster drop in pressure so an even earlier indication of a leak. Unable to freeze flow of water, you can still install EasyFit to pipes with moving water, without the need to turn off the main external / internal service valve. We have a Micro 7mm which has a short thread that fits the CenterRad radiator where the tapping is at 45° to the radiator. 2) How do the Autovents work? The diagram below shows the typical pipework for most homes and who is responsible for maintaining it. There is also a circular ½” BSP valve (Antrax) which has 3 side ports that allow a U key to be used to rotate the valve and screw in/unscrew from a radiator.

Details

Also can be used when you need to isolate a mains water feed to a multi-occupancy building or to maintain a component in a heating system. Save Time and Inconvenience It may also take a few minutes for the water to stop running from your taps, as there will be some water left in the pipes from before you turned the water off. Fitting Aladdin Autovents to radiators helps increase efficiency by eliminating gas and air from radiators automatically. This guide should answer most questions asked regarding the Aladdin Autovents. 1) How do I find the correct sized Aladdin Autovent valve for my radiator? BSP is approximately 14.5mm. If you use the ¼” BSP thread for your radiator, then it will need PTFE tape fitted on the outside of the bush.