Devcon 5 Minute Epoxy - High Strength

Product Information

Strong enough to fill gaps. Sets in 30 minutes, cures in 12-16 hours to a clear transparent finish. Excellent for jewellery.

Mixing Plastic Steel Putty (A) is formulated to be a dense mix that can be applied easily to overhead and vertical surfaces without running or sagging. For the 500g and 1Kg kits, empty the Resin and hardener onto a mixing board and mix using a spatula. Do not mix in the containers. For the 10Kg kit, add the hardener to the resin and mix using a T shaped mixer or Jiffy ES mixer attached to a power drill. Fold the material by vigorously moving the mixer up and down until a uniform mix has been achieved. Once mixed, immediately spread out the mass of material onto a suitable area before use to avoid a rapid exotherm and associated reduction in potlife. If surface is oily or greasy use Devcon Fast Cleaner 2000 Spray/Cleaner Blend 300 to degrease the surface.

Grip 5 Minute Epoxy 250g

Works on metal, stones, ceramic, crystal, china and wood. Waterproof and resistant to most chemicals. Chemical cleaning with Devcon Fast Cleaner 2000 Spray/Cleaner Blend 300 should follow all abrasive preparation. This will help to remove all traces of sandblasting, grit, oil, grease, dust or other foreign substances. Devcon® Flexane® Putty Repairs and Devweld 531 Provide Corrosion Protection to Petrochemical Holding Tank Devcon® Titanium Putty & Devcon® Brushable Ceramic Coatings Repair & Protect Pressure Vessel from Corrosion For complete safety and handling information, please refer to Material Safety Data Sheets (MSDS) prior to using this product.

Always try to make the repair as soon as possible after cleaning the substrate, to avoid oxidation or flash rusting. If this is not practical, a general application of FL-10 Primer will keep metal surfaces from flash rusting. Under cold working conditions, heating the repair area to 38ºC – 43º C immediately before applying any of Devcon’s Metal-filled Epoxies is recommended. This procedure dries off any moisture, contamination or solvents and assists the epoxy in achieving maximum adhesion to the substrate. Proper surface preparation is essential to a successful application. The following procedures should be considered: Devcon® Wear Guard™ 300RTC High Chemical Resistance Coating Reduces Pump Repair Frequency at Platinum Mine Industrial strength two-part epoxy is designated for heavier items requiring an extra-high-strength bond.

Epoxy Thinners 150ml

A shelf life of 3 years from date of manufacture can be expected when stored at room temperature (22ºC) in their original containers Application: Point the dispensing tip at the proper location for applying the glue or epoxy. To keep a steady flow, smoothly move the gun applicator over the surface while holding down the trigger. ITW Devcon will replace any material found to be defective. As the storage, handling and application of this material is beyond our control we can accept no liability for the results obtained. Metal that has been handling sea water or other salt solutions should be grit blasted and high pressure water blasted and left overnight to allow any salts in the metal to ‘sweat’ to the surface. Repeat blasting may be required to ‘sweat out’ all the soluble salts. A test for chloride contamination should be performed prior to any epoxy application. The maximum soluble salts left on the substrate should be no more than 40 p.p.m. (parts per million).