Bosch Professional Table Saw GTS 635-216 (1.600 W, Incl. 1 X Circular Saw Blade, Optiline Wood, 216 X 30 X 1.6 Mm, 22, in Cardboard Box)

Product Information

Jediná vada na kráse byla, že vnitřní část s motorem byla pro účely přepravy výrobcem fixována umělohmotnou páskou, která se ovšem během přepravy přetrhla, takže motor + vnitřní pohyblivý mechanismus měl možnost se mlátit sem a tam. No ale po prohlídce se naštěstí nic nepoškodilo. The GTS 635-216 Professional’s high cutting width is achieved as its rip fence is extended beyond the edge of the saw table and serving as a support. This allows panels of up to 635 millimetres to be cut to size. So, given the larger and heavier table, your workpiece will be better supported on the 10 XC. But if you really want to, you can make the same large cuts on the small 635-216 as you can on its larger brother. 635mm is large enough to cut a standard sized plywood sheet in half on the short side. Power The DWE7485 on the other hand is just under €500 (but cheaper in the US), quite a step up from the other two saws. This means it will have to have some serious improvements over the other two saws to be good value for money. Special event, club or membership offers, third party promotions or prices not available to the general public

Which then is the better saw? The answer is simple: the GTS 10 XC. It is larger, more powerful, more stable, has a better miter gauge and sliding table, and a better fence. It also uses higher quality materials. Pila je skutečně o několik úrovní nad těmi, které jsem dosud měl. Umožňuje přesné a spolehlivé řezy, protože se všechny parametry dají přesně seřídit. Výkon motoru je dostačující, nastavení bočního dorazu je opět velmi jednoduché a exaktní a doraz je fixován jak zepředu, tak i ze zadní strany.Works extremely precisely and is exceptionally versatile due to integrated slide carriage, table-widener, and table extension The sliding table does cost about €100, but even then the TS 254 M comes in cheaper than the DWE7485. The miter gauges on these three saws are similar. They are all quite basic, and have no stops that can be set to ‘remember’ specific angles. This means every time you change the angle, you’ll need to re-measure to make sure it is accurate.

The name sounds complicated, but it is actually quite simple: 635 stands for the maximum rip capacity, and 216 stands for the maximum size of the blade in millimeters. Compared to other Bosch table saws Safe and easy transport due to low weight (22 kg), ergonomic handles, and protective onboard storage The TS 254 M actually comes with such a support bar included, made of the same material as the table top. It is sloped so you can use it for angled cuts as well. Another thing it has over the other two saws is that it can be adjusted for play. There are two screws or bolts that you can turn to make it slightly wider or narrower. This makes it fit exactly in the miter slot, eliminating any sideways movement.Given the DeWalt’s premium price, you’d expect it to have a better internal build quality too, but it’s hard to tell if that is really the case. But it is also more than twice as expensive. This makes the GTS 635-216 very good value for money. It may not be as well built, or have as unique features at the 10 XC, it can cut almost the same height and rip the same width. With some attention, you can achieve the same results on the 635-216 as on the 10 XC, but for less than half the money.