Aruba Wireless Network Access Point, 802.11ac, Instant Model (IAP-205-US)

Product Information

Regulatory compliance (for more country-specific regulatory information and approvals, please see your Aruba representative): All numbers above are without an external USB device connected. When sourcing the full 5W power budget to such a device, the incremental (worst-case) power consumption for the AP is up to 5.7W (PoE powered) or 5.5W (DC powered). Usage—Provides a snapshot of the WAN usage and is available for All Traffic, Internet, and VPN specific information. You can see the incoming and outgoing traffic for the AP with time plotted on the x-axis. Hover over the chart to see the incoming and outgoing traffic for a particular time frame. OFDMA allows access points to handle multiple Wi-Fi 6 capable clients on each channel simultaneously, regardless of device or traffic type - improving efficiency and reducing latency. Two spatial stream Single User (SU) MIMO for up to 574 Mbps (287 Mbps) wireless data rate with individual 2SS HE40 (HE20) 802.11ax client devices or with two 1SS HE40 (HE20) 802.11ax MU-MIMO capable client devices simultaneously

AP-615: Integrated downtilt omni-directional antennas for 2x2 MIMO with peak antenna gain of 2.8dBi in 2.4GHz, 4.5dBi in 5GHz and 4.5dBi in 6GHz. Built-in antennas are optimized for horizontal ceiling mounted orientation of the AP. The downtilt angle for maximum gain is roughly 30 to 40 degrees. radio: Four spatial streams MIMO for up to 4.8Gbps wireless data rate with HE160 802.11ax client devices The device is connected with Aruba Central but the device reachability data for WAN or VPN is not available in Aruba Central, the chart appears in white color. The UTB feature was not supported on the initial AP-635 hardware, but was introduced in a hardware revision. See Aruba Field Bulletin AP2205-1 on the Aruba Support Portal for more details In the Health Status graph, the Poor Health Limit text indicates the poor health limit of the device in the network.

POE power can be drawn from either port (single source, or set to prioritize) or both ports simultaneously (set to combine) When set to prioritize, the AP draws power from E0 and may failover to E1.

Powering the AP from a single 802.3af (class 3 or lower) POE source is not supported (except for AP staging), regardless of IPM statusThe Network section displays information of the network and interfaces to which the AP is connected. Along with the network profile name, the following fields are displayed in the Network section: When configured for concurrent operation in 5GHz and 6GHz (only), the U-NII-4 band will be disabled DC power interface: 12Vdc (nominal, +/- 5%), accepts 2.1mm/5.5mm center-positive circular plug with 9.5mm length Speed (Mbps)/Duplex—The speed of the network measured in Mbps. This field also indicates whether the network has a full-duplex or half-duplex communication.