Joined in 2023 
82 
63 About this deal
This Limited Warranty covers any defects in material or workmanship under normal use during the Warranty Period.
Absolutely! With no acid or venting, this battery can be installed in any configuration except for upside-down (terminals facing down). Let’s say you setting this at 10%; when you get to 10%, the Smartshunt will indicate 10% remaining and 0 minutes until empty. If you choose to fully discharge your battery (not recommended) then set this to 0%. If you want to be more conservative on your time remaining, then set this to 20% Settings for Victron MPPT Charge Controllers: Solar assistant is a monitoring tool based the most powerful, low cost and globally available device on the planet: the Raspberry Pi. SolarAssistant provides metrics of your entire solar system live up to 2 seconds. SolarAssistant is a standalone system that can be used without the internet. However, when you are away from home, all features are available remotely via the internet. What information is available with SolarAssistant? The screen will automatically turn off after 30 seconds of inactivity. Press the “Menu” button to re-activate the screen. ControlsNow, the indicator for protocol should read as “Pylon 485”. You can now close the software and disconnect the RS232 cable. The SOK 100ah Lithium Deep Cycle battery has been on the market for over a year and is one of the best selling batteries for good reason. This battery will do what you need it to, and it lasts a really long time - 4000-8000 cycles! Great for Vanlife, RV's, Off-grid cabins or anything that needs reliable power. In the event of a CANBUS communication failure, the parameters set within various devices such as inverter/chargers and solar controllers will be utilized in an open-loop configuration. It is highly recommended to set these devices to appropriate LiFePO 4 settings as described here to prevent over/undercharging. Sol-Ark Communication
Hold your pre-charge resistor with one side making connection to the main negative cable you removed in step 2, and the other side touching the negative terminal the cable would normally connect to When compared to AC wiring, Low-voltage DC systems are very susceptible to voltage drop. Long cable runs between batteries and inverters can lead to premature low-voltage shutdown when heavy loads are turned on. For optimal performance, keep your batteries as close to your inverter/charge controllers as possible. Temperature Experience reliable and long-lasting power with the SOK 12V 100Ah Lithium-Iron Phosphate (LiFePO4) Deep Cycle Battery. It’s designed to exceed expectations and deliver unparalleled performance for all your power needs. Whether you’re embracing the freedom of van life, enjoying the comforts of an RV, or powering your off-grid cabin, this battery is your dependable energy companion. Don’t settle for less when you can have exceptional value with an SOK Battery! Capacity and Voltage For those who live off the grid, have solar panels or want to start using renewable energy sources an SOK 100AH LiFePO4 battery is a great investment.If you wish to use your own cable, do so with caution; the following pinout table creates a cable that is unidirectional, so only the end labeled “SK48v100” must be plugged into the battery, and the end labeled “Voltronic” must be plugged into the inverter. If this is reversed, then communication cannot be established. Connector #1 (Voltronic) Switch all 48v DC circuit breakers and/or disconnect to the “ON” position, EXCEPT the breakers located on the front plate of the SK48v100 batteries. Do not turn on the on/off toggle switches on your system. I have been in business for over 40 years, have dealt with hundreds of suppliers, and I can say I have never had a better experience. 100 star rating!
To turn off the BMS, press and hold the “RST” button until the LED lights on the front of the battery being to blink. Release the “RST” button when this blinking is observed. After a few seconds, all lights will turn off indicating the BMS has turned off.If you can, we recommend setting the equalization voltage to 14.6v. With this set at 14.6, if an equalization is somehow triggered, you will not damage your battery. Victron Settings For SmartShunt & BMV-712 / SOK Battery The float voltage is not actually a charging voltage; it is a voltage that can be provided by a charger that matches the resting full-charge voltage of the battery. Some chargers allow float to be disabled, however we do not recommend doing so. By leaving float enabled and set at the recommended voltage, the charger (whether solar or grid) will provide the power to loads FIRST, and the battery will make up for any additional current demanded by the loads. Absolutely! With no acid or venting, this battery can be installed in any configuration except for upside-down (terminals facing down). Who makes the SOK BMS? The SK48v100 battery is equipped with 6 temperature sensors – 4 of them measure the temperature of the cells, 1 measures the temperature of the high-power section of the BMS, and the final sensor is an environmental temperature sensor. These sensors are important for controlling the operation of the BMS, since charging in extreme cold is bad for the longevity of the cells. If any of the 6 sensors detect a temperature below -5°C (23°F), then the BMS will stop allowing charge to enter the battery, while simultaneously still allowing discharge to occur, if demands require discharging. Extreme Cold Discharging
Thorougly inspect the system for any miswiring (loose connections, short circuits, reverse polarity) and correct any issues before proceeding.
What temperatures do the batteries need to be brought out of the cold?
The SK48v100 Battery has a unique function – the ability to export data logs of up to 2 months of operational history. This is particualarly useful for intermittent issues, as the logs can give insight to every measurable data point with a correlating data/time stamp. What’s required: The SK48v100 has been tested by Intertek Laboratories and has been certified to conform to UL 1973 standards.
Great Deal 
New Comment