Gorilla 84756 Waterproof Coat & Seal Black 473ml

Product Information

We cannot confirm Gorilla Waterproof Patch & Seal is non-toxic, so it is not recommended for this type of application. Store in a cool dry location. After each use, remove excess product from the rim of can with a dry cloth. Press or lightly tap lid shut to create tight seal. Gorilla Waterproof Patch & Seal is best applied at room temperature (it will not adhere to cold surfaces). Once applied it can withstand temperatures between -56°C to 93°C. The approximate shelf life of Gorilla Waterproof Coat & Seal is up to 2 years, unopened from date of manufacture. Once opened it will be dependent on storage conditions and age of the product. We strongly recommend wearing gloves while working on any project using Gorilla Waterproof Coat & Seal. If you do get it on your skin, try wiping it off with a dry cloth or paper towel. For cured material, try washing with soapy water to loosen the coating. Dry your skin and apply lotion. We do not recommend using any kind of alcohol, acetone, or other solvent on the skin. If irritation occurs seek medical advice and have product container or label at hand.

Gorilla Waterproof Coat & Seal can be applied between 10°C and 48°C. Once cured, it can withstand temperatures between -40°C and 100°C. To remove Gorilla Waterproof Patch & Seal Sprays from your fingers and nails, we recommend following these steps: We strongly recommend wearing gloves while working on any project using Gorilla Waterproof Patch & Seal Liquids. If you do get it on your fingers or nails please follow these steps: We believe strongly in the inherent rights of animals. Therefore, The Gorilla Glue Company does not perform any kind of animal testing. The approximate shelf life of Gorilla Waterproof Patch & Seal is up to 2 years, unopened from date of manufacture. Once opened there is no standard time, it will be dependent on storage conditions and age of the product, up to 9/12 months is a good guideline.

IS GORILLA WATERPROOF PATCH & SEAL TAPE FOOD SAFE?

This material will be difficult to remove from a surface. For wet material, immediately wipe. Use mineral spirits to clean applicators such as brushes and rollers. A textured surface will be much harder to clean than a smooth one. For cured material, a solvent may soften the material but could damage the surface around/underneath. Gently cut or scrap the material to try and remove.

Stir contents for 30 seconds until it is thoroughly mixed. After first use, slight skinning may occur. If this occurs, remove the layer and stir contents for 30 seconds.This material will be difficult to remove from a surface. For wet material, immediately wipe with a dry cloth or paper towel. For cured material, a solvent may soften the material but could damage the surface around/underneath. Gently cut or scrape the material to try and remove. A textured surface will be much harder to clean than a smooth one. Use mineral spirits to clean applicators such as brushes and rollers. Shake the can well. Once the marble inside the can is heard moving, shake for 30 seconds to get a good mix of the coating and propellant to ensure an even application. This material will be difficult to remove from a surface. For wet material, immediately wipe with a dampened rag. For cured material, a solvent may soften the material but could damage the surface around/underneath. Gently scrap the material to try and remove.