Heavy Duty Picture & Mirror Hanger Z Bar/French Cleat - Floating Hanging System + Fittings - 300mm

Product Information

It features wall mounted storage bins and floating shelves that all hang on French cleats! Both of the drawer units shown below hang on a single French cleat to ensure that the tops are perfectly even. How to install a French cleat

For a French cleat system to work, you will need a straight and true surface. If your walls are uneven or you think the system will need some extra support, it can be a good idea to clad the area where the cleats will be mounted first. Use matching plywood or large sheet timber for a contrasting look. Its design, safety features, material and method in hanging are what makes the overall quality of French Cleats a crowd-favorite. With these in mind, it’s safe to say that they are the go-to hanging hardware when you want to hang something on the wall with confidence. Simple, stylish and endlessly practical, a French cleat system utilises near-flat vertical lengths of timber with a 45 degree angle cut. These angled cuts are used to hook on accessories that have a compatible 45 degree hook attached, allowing you to tidy your workspace and organise your tools. Be sure that the type of adhesive you use works well with the aluminum cleat as well as the material your frame is made of. You also have to make sure that it has a strong hold on both surfaces. Unfortunately, we cannot advise on how much weight the cleats can hold using adhesive, so this would require some testing.I like to make these cuts on top of a sheet of foam insulation that I keep around just for this purpose. It keeps the entire board supported, and I can cut into it without damaging my workbench underneath! Set the blade angle To get the most accurate cuts, I recommend making a circular saw jig, using a circular saw guide, or just clamp an extra board down to guide the saw in a straight line. These methods can work for a jig saw as well. A crooked cut will make your cleat hang crooked! We have made a timber jig for this construction to aid speed, accuracy and repetition. If you prefer, you can measure and mark as you work, using a tape measure or metal ruler. To maximise the sheet timber, we have designed our cleats so that they are 5 inches or approximately 130mm wide. You can easily tweak this measurement to suit your space and custom design. You can add as many or as few shelves as you like depending on the room you have available, and there’s plenty of room to get creative and come up with a design that suits your space.

That’s why knowing what picture hanger is best for hanging large and heavy objects is very important. You should be able to hang things on the wall with confidence, not fear . Inspect the cables and blade of the chop saw and circular saw before they are plugged in, to ensure they are in good condition. If any of the elements need to be replaced, make sure this is done before construction begins. You may slide the frame left or right to center on your wall, however, both cleats need to be engaged 90% of their length for strength and stability. To remove, lift the frame upward a few inches to disengage the cleats .Make sure to level the cleat while installing — small adjustments to level the cleat can be made by moving slightly in the slotted screw holes before tightening the cleat to the wall. Somewhere on your saw, there should be a knob that allows you to tilt the blade. Loosen the knob, then set the angle for 45 degrees. For safety, we recommend wearing protective goggles, a dust mask and heavy-duty gloves when using a chop saw or drill.