StopGap Floorboard Draught Excluder - Brown

Product Information

Cat flap - admittedly, does let in a little bit of a draught, but I put a cushion against it when the cat was kipping, and the draught was STILL THERE. Follow this simple eight-step guide to eliminate chilly draughts and improve a rooms overall insulation. This is a squishy, stretchy dark grey sausage available in different thicknesses for different gap sizes. Punching the nails in wasn't without it's hazards either especially if electric cables passing through the joists below were in the top third of the joist. Manufactured from flexible V-shaped plastic that springs apart to fill gaps from 1-8mm, easily pushed into the gap using a debit card or similar tool, once in place the draught excluder is invisible.

To my eternal shame I also joined in when old sanitary ware which had been removed was used as targets for bricks with great excitement and cheering when the first brick landed on target. If you are looking to fill floorboard or skirting board gaps that can't be covered by this size of DraughtEx we offer a full range of different sizes to suit all gap widths. for a 40m roll), thin V-shaped plastic that springs apart to stop draughts in floorboard gaps of 1-8mm. For this technique, you mix sawdust with a glue or resin to create a bulky liquid that your place between the boards, which hardens to form a more robust filler.We had gaps between our floorboards in a variety of sizes which made it a slightly trickier job, but it has been SO worth it. I bought a set of sealant smoothing tools by 'No Nonsense' to get a perfect finish and personally wouln't attempt it without these cos its a messy job!

The gaps in between stripped floorboards may add up to the size of a small window; therefore draught-proofing your floor is essential and can shed pounds from your energy bill, paying for itself in less than 12 months. I have the foam draughtex stuff and have used it in about 1/3 of the room, jute rope, wood bits and filler for the rest. If you are on a small budget, then the traditional technique of papier-mâché may be the best option. Alternatives to the tube-like rolls, which are pushed into floorboard gaps, are thin V-shaped, one-size-fits-all, plastic lengths that spring apart when pushed into place using a credit card. If you put some kind of squashy draught excluder on the skirting bottom edge, I can't see that being a problem.Cold air flowing in from either the outside, or an unheated area of the house will cause you to feel cold and turn your heating up. Push the sealant strip into gaps: Once the first few inches are firmly in place use the applicator to gently push the sealant into the rest of the gap. DraughtEx comes supplied with a free applicator and comes in 3 sizes, thin for gaps of 3mm or less, standard for gaps of 2 – 7mm, and large for gaps of 6-11mm.