EVAPO-RUST® C700 Rust Remover, 946 ml

Product Information

If the result isn't successful, try making it once more. In this way you'll get more effectiveness. But don't try to make it 100 % clean with the liquid, just remove the rust - that's all. If you have Evapo-Rust to spare, you can use it to rinse off the remaining rust debris from the metal item. Either submerge the item in a new vat of Evapo-Rust or put the item in an empty container and pour the product over it. Next, let the metal item air dry. The benefit of rinsing with pure Evapo-Rust is that you get some minor rust protection before you apply a more long-term anti-rust solution. Reusing the Evapo-Rust Properly Depending on the metal and the severity of the rust and the required level of de-rusting it can take anywhere from 12 hours up to as long as 1 week (or more) for the chemical reaction to finish This really isn't cost effective to be used on large parts, but for small items it works quite well. Leave the item to soak for a few hours, then under running water scrub the rust off with a wire brush. The surface will be left with a matte grey finish that's very easily polished with scotchbrite.

Most people would discard used rust remover, and doing that with Evapo-Rust is easy; it’s biodegradable and non-toxic, so you won’t be harming the environment. However, don’t throw away the used Evapo-Rust. It can be reusable, so I advise keeping it in a separate container (more on that later). Step 5: Clean the Item David: We make a lot of products and we’re constantly working on more. We have products that prevent rust from even occurring. We make a version of Evapo-Rust that’s really cool, it’s called Thermocure. If your car is running hot, you just put Thermocure and water in the cooling system and drive around with it. After a few days, you drain the product, and all of the rust comes out, which is the cause of the issue. Then your car starts running cool.it's fully earth-friendly and doesn't cause any harm to nature, groundwater, living organisms or whatever; The product can be re-used until its effectiveness starts to wear off. In general, one gallon of Evapo-Rust® will remove 1/2 pound of pure dry rust. Since rust is 1/17th the weight of iron, the workload is quite substantial. However, there is one clear difference between acids and Evapo-Rust. While an acid will definitely get rid of rust, it also tends to eat away at the metal underneath. So, you’ll get rid of the iron(III) oxide, but lose a lot of healthy iron in the process. EVAPO-RUST® rust remover works through selective chelation. This is a process in which a large synthetic molecule forms a bond with metals and holds them in solution.

Earlier, I mentioned how important it was that Evapo-Rust has to completely cover the rusted item. And I do agree with that, to an extent. When the item is completely under the surface, the product can react equally on all sides. So, if you have enough of Evapo-Rust, feel free to pour as much as you need. SAFR is an automotive finish remover, i.e. its primary purpose is to safely remove any coat of paint from your vehicle. However, just like Safe-Erase, you can use it on walls, wood, plastic, and other surfaces. In addition, the process of applying and removing SAFR is the same as the one with Safe-Erase when it comes to vintage car paint. In short, you apply the gel, wait for a while, then scrape the debris off. Try to arrange optimal safety for all surrounding parts. If the rust remover gets to paint, it's likely to destroy some protective layers, so make sure you won't let it spill all over the car while working. Cleaning the metal item involves rinsing. However, interestingly enough, you can go about it in two different ways. Rinsing with WaterThe wire brush was hard to get into the annular ring gear, but the rust is loose there. Notice how clear and readable the letting is.