M14 (14mm x 50mm) Hex Bolt (Fully Threaded Setscrew) - Steel (Pack of 10)

Product Information

Nominal screw sizes M5 and larger have six drilled holes spaced 60 degrees apart unless the purchaser specifies two drilled holes. For bolts with cut threads where the threads do not comply with EN 1090 the relevant resistances should be multiplied by a factor of 0. Drilled head metric hexagon socket head cap screws normally are not available in screw sizes smaller than M3 nor larger than M36. Before you design your next product or make updates to an existing product, consider partnering with Optimas to take advantage of our many capabilities.

Zinc Flake coated high tensile steel class 10 - a higher tensile non-stainless grade for screws and bolts. In addition for countersunk bolts the bearing resistance F b,Rd should be based on a plate thickness t equal to the depth of the connected plate minus half the depth of the countersinking. the bearing resistance F b,Rd of the bolt is not affected by the spacing p 1, p 2 and edge distances e 1, e 2 provided that the following limits are observed: e 1≥ 3.It is a highly ductile and malleable material, enabling copper washers to create tighter seals and withstand vibration better than steel. A2 stainless steel is perfect for outdoor applications exposed to the elements as they will not be prone to rusting.

where e 1 is the distance between the center of the end bolt and the end of the plate measured parallel to the load direction, p 1 is the distance between the centers of neighboring bolts measured parallel to the load direction, and d 0 is the diameter of the bolt hole.is only valid when the bolt is used in holes with nominal clearance not exceeding the values given in the standard EN 1090-2 'Requirements for the execution of steel structures', as specified in EN1993-1-8 §3. d m is the mean of the across points and across flats dimensions of the bolt head or the nut, whichever is smaller. The punching resistance of the bolt B p,Rd should be verified against the applied tensile load F t,Ed in accordance with EN1993-1-8 Table 3.