Skullcandy Sesh Evo True Wireless In-Ear Bluetooth Earbuds Compatible with iPhone and Android/Charging Case and Microphone/Great for Gym, Sports, and Gaming IP55 Water Dust Resistant - Black

Product Information

To ensure re-pairing, please unpair or "forget" your SESH® EVO in your paired Bluetooth device list. (?) When charging, the lights of the charging case will be red. When fully charged, the lights will turn off.

It's the main issue I had with these earbuds, and while it's because of an extra feature that these steps are required, I have to say I wouldn't mind giving up the solo mode to make pairing the earbuds more simple. Even then, nearby sounds like traffic — and especially heavy traffic or loud commercial vehicles — will regularly drown you out, making it difficult for your callers to hear you.Power on ONLY your LEFT SESH® Wireless bud by simply removing it from the case. It will be in a NON_CONNECTED or non-paired state due to Bluetooth being off on your device. Leave the other RIGHT bud is in the case When charging the device, we recommend using a cable, charger, or outlet with a power output that does not exceed 18-Watt (5 Volts/3.6amps). The button mechanism sits under a membrane, which keeps them safe from dust and water, but it also makes them harder to press. After some trial and error, I found the easiest way to use them was to press a finger against the membrane, then press a little harder until it triggered the mechanism. It’s kind of like the press-halfway-to-focus system on camera shutter buttons. The most critical thing is to get a good seal with the available eartips. Without this, the earbuds will sound downright dreadful — both hollow and tinny.

The Skullcandy App runs on mobile devices - iOS and Android operating systems alike. At this time laptops and tablets are not supported, though we are exploring expanding our device coverage. If you have Indy Evo, Indy Fuel, or Push Ultra earbuds, you will notice EQ modes displayed but the inability to select which mode is utilized from the Skullcandy App interface. This is due to technical limitations at this time that requires you to use the button controls on your earbuds to cycle through different EQ settings. You will hear a tone to indicate the sync was successful and ONLY the LEFT bud will begin to flash RED/BLUE.Step 1: Remove the earbuds from the charging case. Then, place them on it again, and make sure that both earbuds LED lights turn red. Please make sure you have enabled Bluetooth and Location permissions for the app. If you have declined Location permissions, for example, you may have to go into the app settings and re-enable. Once wedged into my ear canal, they sat very securely — I felt no need at all for an additional earfin or other supports. To ensure ease of re-pairing, please unpair or forget your SESH® Wireless in your paired Bluetooth device list You will be able to listen up to 30+ feet (10+ meters) away from your paired device, though your connection experience may vary based on your environment.