About this deal
You can see tell where the previous print was on the build plate as the 3DLAC residue comes off with the print, so if you want to really maximise your usage you can place your next print on a different part of the bed and so on. Especially for 3D printers feature 'Heated Bed' or "heated bed" although it is also valid for 3D printers with cold base. Nylon printing presents unique challenges and opportunities, and we want to ensure you have everything needed for outstanding results.
It is absolutely crucial to keep in mind that if air shipment is required, the 3DLac Stick should be purchased as it is safe and therefore viable for air shipment without restrictions. The cap should be put back on the bottle after each use, as failing to do so will cause the applicator to dry. When removing the parts take special care, we recommend waiting until the temperature of the base is below 30 ° C and in case you do not remove the piece, let it cool in the refrigerator and the piece will be released only with a light touch. The printing base should be allowed to cool down (at least to 30 ºC) before the part is removed from the printing bed. A light 3DLAC mist over the surface is enough to hold completely the first layer of plastic to the base.A product capable of fixing what was needed in each part of the printing process and which meets our conditions was essential. Together, they actively contribute to the 3D printing community by sharing knowledge, resources, and cutting-edge solutions, further cementing their position as leaders in the industry. It should always be applied on a clean and dry surface by gently pressing the applicator against the printing surface for a few seconds until the product starts flowing. Note: PLA and PETG sometimes adhere so well in combination with 3DLAC stick that they are a bit difficult to remove.
We’re dedicated to enhancing your nylon 3D printing experience with a comprehensive nylon starter pack. In our experience, the the first time you use 3DLAC on your build surface apply two light coats (remember to shake the bottle before spraying).function is to hold the first layer of plastic so that it does not move at the start of printing, preventing unwanted failures in the early 3D printing process.