YORKING Brake Pipe Repair Kit 3/16" Pipe Flaring Tool Kit 25FT Car Brake Line 10mm Replacement Cutter Bender Brake Line Repair Kit for Car Original Braking System

Product Information

Premium Material] Brake tube kit is made of high-quality flexible brass, durable, convenient, and won't rust.

The time has come to fit new brake lines, I intend to make my own so will need a cutting/flaring kit.

If any are leaking then tighten them up and recheck them again by pressing and holding the brake pedal. You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice. This one was so badly made it necked the pipe just under the flare - actually caused a failure on my race car. In a vice it worked well, until I loaned it out and the idiot dropped it and broke the tip off the male former. I was thinking of warming up the steel line first before flaring it but I actually have no idea if brake fluid is flammable or not.

Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place. While all brake flaring tools will work with "pure" copper pipe, only the expensive tools tend to work with kunifer copper pipes. The passenger side was OK, Drivers side unfortunately went to undo the brake pipe nut on the chassis end of the flexi and it appears to have been rusted to the pipe so the pipe kinked.I was going to replace the piece of the line from where its behind the rear wheel liner to the caliper. Please ensure you have read the information in the above sections and that you have the correct tools available.

As expected they were perfectly sound, just the plastic film cracking and some surface rust with some light pitting.If you use steel brake pipes then you need to disassemble and drop the car's subframe, as steel cannot be threaded into place like copper. Looking around it seems that a tool such as this would enable me to replace a small part of the existing pipe. Note; Brake lines are a safety critical component and should only be repaired or made by competent persons with sufficient knowledge and experience to complete the work to a safe standard. If you go to an independent garage your rusty steel brake pipes will probably be replaced with copper ones - they don't rust and they're easy to put into the car without stripping it down.