Bosch Dishwasher Water Inlet Electronic Valve (Genuine part number 091058)

Product Information

The inlet valve on a dishwasher is a fundamental component responsible for regulating the flow of water into the machine. It acts as a gateway, allowing water from your home’s water supply to enter the dishwasher during the wash and rinse cycles. A water inlet valve is a device that contains a large number of pieces to ensure smooth water flow. If you find any damage, then you need to change the inlet valve which requires a bit of expertise. I will explain later how to replace the water inlet valve. But if you have less time, then you should take professional help to do the replacement proficiently. First, switch off the machine and turn off the water supply line before starting the replacement process. Remove door’s screws Your dishwasher now fills up slowly. Does it seem like it takes forever to get the water running in your washer? Do you notice your dishwashing loads taking longer and longer to complete? Well, it might be a failing inlet valve that’s to blame.

Now place the new valve using the two quarter-inch screws in the same position where the old ones are situated. A screwdriver will enable you to remove the front panel of your dishwasher to access the water inlet valve. 2. Cleaning Solution

Next, a Closer Inspection of the Water Inlet Valve

Detach the water inlet valve carefully and keep the fitting. Remove the two quarter-inch screws from the inlet valve. A malfunctioning dishwasher inlet valve can cause various issues, and there are several signs to look out for to determine if the inlet valve is not working correctly. Here are some common indicators that your dishwasher’s inlet valve may be faulty:

If you’re like most homeowners, you should never attempt a DIY repair on a water inlet valve. It’s not as straightforward as you might think!

Insufficient Water or No Water Entering the Dishwasher: One of the most obvious signs of an inlet valve problem is when your dishwasher doesn’t fill with water, or it fills with too little water. If you open the dishwasher during a cycle and notice that there is no water at all, it’s a strong indication of an inlet valve issue. Before you begin the cleaning process, it is important to gather the necessary tools. You will need a few basic items: 1. Screwdriver The inlet valve stops working when the electrical components stop functioning correctly,’ says Melanie Musson.

Typically, the appliance will be supplied with fixing screws that go through the carcass from the inside to the worktop above and the cabinet sides. The appliance will stand directly onto the floor so adjust the legs to raise the appliance to the correct position and fix in place. If you’re attaching a plinth across the base of your cabinets, you may need to cut a groove in the top edge to allow the correct door opening. Fixing the decorative door Appliances should be switched off and disconnected from the mains when undertaking any type of repair and this is extremely important here.The appliance should be supplied with the correct fixings to attach the door. Once attached and aligned with the rest of the cabinet doors, ensure you adjust the tension springs in the appliance carcass so that the door opens smoothly and doesn’t slam. Top tip