About this deal
Three specific edge clips have been approved by Huber for that application: the Simpson Strong-Tie PSCA7/16, the Simpson Strong-Tie PSCL7/16, and the Tamlyn PCS7/16.
Google has not performed a legal analysis and makes no representation as to the accuracy of the date listed.I. Planning on nailing the curled edged down and them applying roofing felt over the top before putting the metal sheets down. Like 24/16 = 24" span on roofing with long dimension across rafters, 16" span for sub-flooring with long dimension across joists. The lead-in 16 eventually rotates such that it comes to rest within an indentation 21 on each end 13 of the arms 12 in a position parallel the surfaces 15 of the building material 11. Under the IBC, 1/2-inch PS-2 panels with a span rating of 32/16 can have an unsupported edge of up to 28 inches, while 5/8-inch 40/20 panels can span up to 32 inches. As it gets further away than your arms can reach, hook it with you hammers claw and lower it further.
Where as you if I remember correctly you were wanting to pre-cut and sort of pre-assemble what you can.If you have a sheet that's just a hair short/long, instead of cutting it, you can pull the nail on that rafter and push or pull the rafter until the end of the sheet is centered on it.