EPAuto Spill Proof Radiator Coolant Filling Funnel Kit

Product Information

You don't have permission to access "http://www.autozone.com/shop-and-garage-tools/funnel/p/oemtools-translucent-no-spill-coolant-filling-funnel-15-piece-set/802197_0_0" on this server.

Funnel KIT with Spill Free NO Spill Cooling System Filling Funnel KIT with

This could be because of trapped air in the cooling system hindering the coolant from getting to the engine. Where the radiator works as it should, burping the coolant system will be the solution. Burping a car cooling system requires time and patience. Depending on the amount of air in the cooling system and your vehicle make and model, burping will take up to 30 minutes to 1 hour. I don't think grandad actually uses sentinel rapid dose ,but is actually showing us the power of GOOGLE what about when the rads are them old 'thorn'roll top with a little bleed screw that direct into the rad, no 1/2 tapping ? Remove the overflow cover and switch the heater settings to max full. Fill the reservoir tank to the COLD mark. Start and allow the engine to idle for 30 to 45 minutes. The coolant will drop as the trapped air escapes from the cooling system. How do you burp a motorcycle radiator?

Turn on the vehicle and allow it to run. Now, you need time and patience. Allow the engine to run at the average operating temperature so the thermostat will grant coolant passage to cool the engine. Once the thermostat opens, the coolant on the funnel will drop, and you’ll see air bubbles coming from the radiator. That is the trapped air getting out of the system. I have sentinel pressurised container ,as well as rust buster does everything in seconds without diy botching and no spills

OEMTOOLS 87009 No-Spill Coolant Funnel Kit, Near Universal OEMTOOLS 87009 No-Spill Coolant Funnel Kit, Near Universal

Osuagwu Solomon is a certified mechanic with over a decade of experience in the mechanic garage, and he has over five years of experience in the writing industry. He started writing automotive articles to share his garage experience with car enthusiasts and armature mechanics. Pour coolant into the funnel and let it go above half. This is to avoid coolant spillage when you start the vehicle. Start the car and allow it to warm up. Once the engine gets to the average operating temperature, the thermostat activates, allowing the coolant to rise and fall as it opens and closes. The trapped air escapes as the coolant rises and falls.Here a bit more ino in Rapid DOse, you can get fluids into pressureised or unpressurised systems in 3 ways, Radiator 1/2 BSP, Radiator Vent pin, Filing Loop Now, remove the spill-free funnel following the instructions on the funnel kit and recycle the coolant into a container.